EzLounging

kimchi wrote: ↑Fri Dec 30, 2022 8:13 pm I was secretly hoping you wouldn't dig them so you'd sell them to me lmao. But glad you're feeling it.

kimchi wrote: ↑Fri Dec 30, 2022 4:45 pm

YukonCornelius wrote: ↑Fri Dec 30, 2022 6:52 am

eleveneightnate wrote: ↑Thu Dec 29, 2022 4:28 pm The drama continues... WP got a foot of fresh, so I decided to set up the NOWs on my SB Powder Racer for tomorrow. The bolts are just too short for my Capita boards, which have been known to have deeper recessed inserts than other boards. I took the bindings themselves entirely out of the equation to make sure it wasn't the bushings, so it was just the mounting posts and discs. I can't get half of the bolts started, even doing the washerless method to start, and the ones that do bite only get a 1/2 to 3/4 turn in which doesn't leave me feeling confident.

I even tried my Strata bolts, same deal. Anyone know who makes the longest mounting hardware? Burton says theirs are 16mm, so those might be the call.

how is WP's coverage now? debating there or basin on saturday (might just go skin for fitness reasons at basin and take a few laps before heading back down to denvah)

i actually didn't mind the drive straps on the older versions (think this is like a '17/'18 Drive i'm referring to). curious how the new ones are which i will give a shot next week before ordering burton straps for the drives.

The Drive strap is basically the same AFAIK. Super rigid "FlipIt" strap. I can't stand that strap, but a few buddies have told me they prefer that complete lack of flex.

coleslawed wrote: ↑Sat Dec 31, 2022 7:32 am curious about why the ankle strap swap, that’s the part I’m most interested in off the Pro’s.

pow_hnd wrote: ↑Wed Dec 28, 2022 4:14 pm

tracer wrote: ↑Wed Dec 28, 2022 3:36 pm

pow_hnd wrote: ↑Wed Dec 28, 2022 1:19 pm Full Burton on my Drives all day long...

Sick
Hey, I couldn't get the burton toe ladders and "connectors" to fit into their slots. Did you have to mod anything there?

You had EST version. Re-Flex is the version that fits

tracer wrote: ↑Sun Jan 01, 2023 2:38 am

pow_hnd wrote: ↑Wed Dec 28, 2022 4:14 pm

tracer wrote: ↑Wed Dec 28, 2022 3:36 pm

Sick
Hey, I couldn't get the burton toe ladders and "connectors" to fit into their slots. Did you have to mod anything there?

You had EST version. Re-Flex is the version that fits

Nerp, Re-Flex Genesis. The doubletake ladder doesn't fit. Can't even get it to poke out the top, too thick.

unsuspected wrote: ↑Sun Jan 01, 2023 5:38 am

tracer wrote: ↑Sun Jan 01, 2023 2:38 am

pow_hnd wrote: ↑Wed Dec 28, 2022 4:14 pm

You had EST version. Re-Flex is the version that fits

Nerp, Re-Flex Genesis. The doubletake ladder doesn't fit. Can't even get it to poke out the top, too thick.

Had the same issue but you have to "pop out" the stopper on the ladder and then put the ladder in from the top. Thanks again @kimchi for point that out.